5/8″ Nylon Lead Rope with Braided Loop #ALR5
$26.00
Description: This 5/8″ Nylon Lead Rope with Braided Loop #ALR5 is made of white medium lay 5/8 inch nylon rope with an eye loop that’s hand braided/spliced in. The tail is braided back to prevent unraveling. The nylon is 10 feet before braiding, making it approximately 8 ft. 6 in. when it’s finished. The 5/8 inch nylon makes a good, stout, lead rope with plenty of flexibility to tie easily. You can read how to properly tie a lead rope by clicking: Take Me To Your Lead Rope.
Related products
-
Nylon Rope Cavesson w/Rawhide Braided Nose #CA1
$155.00Description: The noseband on this 3/16″ Nylon Rope Cavesson w/Rawhide Braided Nose #CA1 is made of round 3/16 inch rope. The nose button and heel knot are covered in hand braided rawhide. The headstall is made of 1/2 inch burgundy latigo leather with a leather loop keeper. The buckle is beveled stainless steel. The headstall leather just below the buckle is handsewn together to prevent the buckle from slipping when the headstall is adjusted. There are hand braided rawhide ring knots on the noseband to hold the headstall in place.
This cavesson comes in small (19 in.), medium (21 in.), large (23 in.) and extra large (25 in.) (see dropdown). In general a small will fit a horse under 14.2 hands and 900 lbs., a medium will fit a horse between 14.2 and 15 hands, a large will fit most horses between 15.1 and 16 hands and the extra large is for those over 16 hands.
Size Measurement: An easy way to be certain to get the correct cavesson size is to wrap a leadrope around the nose where the cavesson will lay, mark the leadrope with a magic marker, straighten it and then measure the leadrope. When measuring, be sure to wrap the leadrope loosely enough that the horse will have enough room between his nose and the cavesson to be comfortable and to be able to hold the bit. A good rule of thumb is 2 fingers width between the nose and cavesson (which is the diameter of most leadropes) if the horse is trained to a cavesson.
This is our favorite for a horse that has advanced beyond the leather and string cavessons. It gives the strongest signal of any of our cavessons. It looks good on a horse.
For more information on cavesson fit and use visit: There’s More to a Cavesson than Meets the Eye: How and Why to Use Cavessons
-
Sliding Running Martingale #CM3
$95.00Description: The Sliding Running Martingale #CM3 has a 3/4 inch adjustable neck strap made of heavy harness leather. Each end of the neck strap is stitched to a stainless steel ring. An adjustable tie down strap is sewn to the center of the neck strap ring on one end and snapped to the cinch on the other end. A second snap with a ring-end is snapped to the opposite side of the center ring of the neck strap. A heavy 1/4 inch nylon cord runs through the ring end of the snap. The nylon cord is 18 inches long and has rein rings at each end. An 1/2 inch latigo leather safety hobble strap with a slit on one end runs from the neck strap through the gullet of the saddle and over the horn. This safety hobble strap prevents the neck strap from sliding to the ears.
How it works: Running martingales are very useful tools to aid horses in learning proper head position as they learn collection. With this martingale, the sliding action of the nylon cord, occurring when the rider pulls on either rein, helps your horse maintain a correct frame as his head turns. If adjusted correctly a martingale does not force the head to stay in any given position but allows the horse a guide for head placement through automatic release of pressure on the reins when correct head placement is achieved. This can make it easier for a horse to reach a more collected frame over time by allowing assistance with head position as the rider teaches the horse to drive from behind.
-
Sliding Gag Bit with Twisted Wire Snaffle #20-42
Price range: $200.00 through $253.00Description: This Dennis Moreland Tack Sliding Gag Bit with Twisted Wire Snaffle #20-42 is built with a center bar on the bit cheeks which limits the movement of the sliding mouthpiece to provide quicker action and instant relief. The hard lay nylon cord allows the bit to slide easily. The cord is attached to a stainless steel buckle which attaches it to adjustable single ply 3/4 inch harness leather cheeks. The twisted wire mouthpiece gives a stronger signal than the common snaffle and is very good to use if your horse has become resistant to giving his nose and/or lowering his head. This snaffle should improve stops in a horse that is trying to run off. This Sliding Gag comes with your choice of a stainless steel twisted wire headstall or, for the more sensitive horse, a 3/4 inch harness leather slide ear headstall or a 3/4 inch browband headstall (see photo).
How it works: The simultaneous pressure on the mouth from the sliding gag bit and on the poll from the twisted, shaped, stainless steel or the leather crown increases control of the nose and improves total balancing power to produce the ultimate in vertical flexion and feel. Because your rein aids are strengthened with the gag, your leg cues given at the same time become reinforced and easier for the horse to respond to. You will be able to better concentrate on fine details of your training rather than large rebalancing or repositioning efforts regardless of your type of riding. This gag bridle is an excellent training tool for both young and older horses that need to improve flexibility and response. Your horse will learn that when it breaks at the poll the release will be instant, smooth, and consistent. Since these gags release so quickly your horse is not trapped in position while it waits for the release to occur. This helps horses stay calm and confident in training and also when they are in competition. The leather crown works well with this twisted wire mouthpiece on horses that want to drop their heads while continuing to pull on the bit.
Although this Sliding Gag is sold without reins, you can choose any Dennis Moreland split reins or roping reins for your sliding gag. To select your reins simply visit the rein category and add them to your order.
If you don’t have experience with sliding gags Dennis Moreland Tack recommends you seek the help of a professional who has experience as you are learning to use them.
-
Bronc Sideline #SL1
$97.00Description: The cuffs on this Bronc Sideline #SL1 are made of 1 3/4 inch doubled and stitched burgundy latigo leather with a leather tab fastener for easy connection and release. The rectangle and Dee are made of smooth round stainless steel rod. The cuffs are connected with 1/2 inch by 24 inch nylon rope. This’ll be one of the handiest tools you’ll ever use.
How it works: To apply the Bronc Sideline just build a loop in the back of the cuff by sliding the rope through, let the colt step in it and pull it snug. Let him settle and then attach the easy-on front cuff. Always use caution when putting the sideline on for the first time. Get out in an open sandy arena with lots of room so your colts or horses will be safe if they react to having their legs connected with the sideline. Once horses learn how a sideline feels they usually accept it and stand quietly. Both sidelines and hobbles can have a very quieting effect on the horse’s mind.
The first time you use the sideline on your horse or while training the horse to accept it use a wide open sandy area. Do not put it on in a confined space until they accept the sideline easily and well. If you are not familiar with the use of sidelines seek help from a professional who is experienced with their use.
-
String Running Martingale #CM4
$48.00Description: The String Running Martingale #CM4 is made of tan 1/4 inch nylon cord. The rings and swivel snap are stainless steel. The safety hobble strap goes through the gullet of the saddle and over the horn to prevent the neck strap from sliding to the ears. This martingale is adjustable both around the neck and to the cinch.
How it works: The running martingale is a very useful tool to aid a horse in learning proper head position as he learns collection. If adjusted correctly a martingale does not force the head to stay in any given position but allows the horse a guide for head placement through automatic release of pressure on the reins when correct head placement is achieved. This can make it easier for a horse to reach a more collected frame over time by allowing assistance with head position as rider teaches the horse to drive from behind.
A good rule of thumb for adjustment is to allow horse to stand comfortably, attach snap to cinch D ring and extend ring straps until they reach the throatlatch.
