German Martingale with Split Reins #CM1C
Price range: $176.00 through $200.00
Description: The German Martingale with Split Reins #CM1C is the same as the German Martingale Complete #CM1A but without headstall or bit. The martingale is made of 1/4 inch tan nylon cord and comes with your choice of 3 harness leather reins: #ASR6 DM Harness Leather Split Reins are 6 1/2 to 7 feet long and work well on smaller horses, the #ASR3 XX Harness Leather Split Reins are 7 to 7 1/2 feet long and a good choice for horses 14.2 to 16 hands and the #ASR2 XXX Harness Leather Split Reins are 7 1/2 to 8 feet long and work well for horses 16 hands and over. See dropdown to order.
How it Works: The key to the German martingale is the long neck strap giving a good line from the bit to the cinch. This allows the neck to lower from the withers before flexing at the poll. The 1/8 inch solid braid cord that runs through the bit to the reins has a high quality hard finish so slides very easily allowing a quick release. The release is more important than the pull but you have to pull to get the release. A horse learns from the release. The safety hobble strap attached to the neck strap goes through the gullet of the saddle and over the horn to prevent the neck strap from sliding to the ears.
Assistance from a professional is necessary to learn safe use of a German martingale.
The martingale is a very useful tool to aid a horse in learning proper head position as he learns collection. If adjusted correctly a martingale does not force the head to stay in any given position but allows the horse a guide for head placement through automatic release of pressure on the reins when correct head placement is achieved. This can make it easier for a horse to reach a more collected frame over time by allowing assistance with head position as the rider teaches the horse to drive from behind.
The labeled diagram shows the Complete German Martingale #CM1A. This German Martingale with Split Reins #CM1C is the same but comes without headstall and bit.
Related products
-
Nylon Rope Cavesson w/Rawhide Braided Nose #CA1
$155.00Description: The noseband on this 3/16″ Nylon Rope Cavesson w/Rawhide Braided Nose #CA1 is made of round 3/16 inch rope. The nose button and heel knot are covered in hand braided rawhide. The headstall is made of 1/2 inch burgundy latigo leather with a leather loop keeper. The buckle is beveled stainless steel. The headstall leather just below the buckle is handsewn together to prevent the buckle from slipping when the headstall is adjusted. There are hand braided rawhide ring knots on the noseband to hold the headstall in place.
This cavesson comes in small (19 in.), medium (21 in.), large (23 in.) and extra large (25 in.) (see dropdown). In general a small will fit a horse under 14.2 hands and 900 lbs., a medium will fit a horse between 14.2 and 15 hands, a large will fit most horses between 15.1 and 16 hands and the extra large is for those over 16 hands.
Size Measurement: An easy way to be certain to get the correct cavesson size is to wrap a leadrope around the nose where the cavesson will lay, mark the leadrope with a magic marker, straighten it and then measure the leadrope. When measuring, be sure to wrap the leadrope loosely enough that the horse will have enough room between his nose and the cavesson to be comfortable and to be able to hold the bit. A good rule of thumb is 2 fingers width between the nose and cavesson (which is the diameter of most leadropes) if the horse is trained to a cavesson.
This is our favorite for a horse that has advanced beyond the leather and string cavessons. It gives the strongest signal of any of our cavessons. It looks good on a horse.
For more information on cavesson fit and use visit: There’s More to a Cavesson than Meets the Eye: How and Why to Use Cavessons
-
Leather Noseband/Tiedown #T8
Price range: $70.00 through $142.00Description: The Leather Noseband Tiedown is made of 1 inch harness leather and lined with burgundy latigo leather. The leather has been edged, hand rubbed, treated with Neatsfoot Oil and hand rubbed again. The buckle is stainless steel with a leather keeper. The leather beneath the buckle is stitched together to keep the buckle in place when you adjust it between horses. The ring is also stainless steel. Shown without a tiedown strap but is available with your choice of a #ZG 1 inch or a 3/4 inch Leather Tie Down Strap or #ZH Nylon Tie Down Strap (see dropdown to order).
How it works: This is the softest noseband I make and will work really well on a sensitive horse or one that wants to use the noseband for balance rather than pushing on it or leaning into it. A very well made noseband that will hold up to many years of hard use.
-
Sliding Gag Bit with Twisted Wire Snaffle #20-42
Price range: $200.00 through $253.00Description: This Dennis Moreland Tack Sliding Gag Bit with Twisted Wire Snaffle #20-42 is built with a center bar on the bit cheeks which limits the movement of the sliding mouthpiece to provide quicker action and instant relief. The hard lay nylon cord allows the bit to slide easily. The cord is attached to a stainless steel buckle which attaches it to adjustable single ply 3/4 inch harness leather cheeks. The twisted wire mouthpiece gives a stronger signal than the common snaffle and is very good to use if your horse has become resistant to giving his nose and/or lowering his head. This snaffle should improve stops in a horse that is trying to run off. This Sliding Gag comes with your choice of a stainless steel twisted wire headstall or, for the more sensitive horse, a 3/4 inch harness leather slide ear headstall or a 3/4 inch browband headstall (see photo).
How it works: The simultaneous pressure on the mouth from the sliding gag bit and on the poll from the twisted, shaped, stainless steel or the leather crown increases control of the nose and improves total balancing power to produce the ultimate in vertical flexion and feel. Because your rein aids are strengthened with the gag, your leg cues given at the same time become reinforced and easier for the horse to respond to. You will be able to better concentrate on fine details of your training rather than large rebalancing or repositioning efforts regardless of your type of riding. This gag bridle is an excellent training tool for both young and older horses that need to improve flexibility and response. Your horse will learn that when it breaks at the poll the release will be instant, smooth, and consistent. Since these gags release so quickly your horse is not trapped in position while it waits for the release to occur. This helps horses stay calm and confident in training and also when they are in competition. The leather crown works well with this twisted wire mouthpiece on horses that want to drop their heads while continuing to pull on the bit.
Although this Sliding Gag is sold without reins, you can choose any Dennis Moreland split reins or roping reins for your sliding gag. To select your reins simply visit the rein category and add them to your order.
If you don’t have experience with sliding gags Dennis Moreland Tack recommends you seek the help of a professional who has experience as you are learning to use them.
-
No Buckle Hobble with Chain Center #H3C
$102.00Description: This No Buckle Hobble with Chain Center #H3C has an easy “on/off latch” that makes it a snap to take on and off your horse’s fetlocks. It is 1 3/4 inches wide and made of doubled and stitched latigo leather. The smooth stainless steel chain link in the center makes it more flexible than similar hobbles with leather centers such as the #H3L No Buckle Hobble. This should only be used on horses that are completely hobble broke.
Visit “Hobble Along” to read my Tack Talk article on proper and safe use hobbles.
For use only on horses that are hobble broke.
-
Chuck Frasier Sidepull #CP40
$271.00Description: The noseband on this sidepull is crafted from firm 3/8″ nylon rope, which is specially designed to ensure it lays correctly from the first ride. The headstall is made of single ply 3/4″ tight-fibered harness leather with a 5/8″ throat latch. This sidepull comes with slot conchos which are the safest and most secure conchos available. You can see the photos on the left for instructions on slot concho removal and application. The buckles on this Chuck Frasier Sidepull #CP40 are stainless steel with the leather below the buckles stitched to keep them in place.
How it works:
Since this sidepull is considered a bitless bridle, it is designed for use on the adult horse and is a great tool to avoid putting pressure on the horse’s mouth while maintaining plenty of control. With the design of this sidepull, the stainless-steel shanks come against the opposite side of the horse’s face with a direct rein pull so the horse starts his turns without leaning. Put your leg on him once the turn is started to teach him to complete the turn without leaning. The noseband in combination with the dog chain curb provides a strong signal to stop.Watch the video “The Secret to using the Chuck Frasier Sidepull” to learn more.
Shown with ASR3 XX Harness Leather Split Reins.
