Adjustable Headsetter with Rawhide Nose #CST3
Description: This Adjustable Headsetter with Rawhide Nose is made of 3/16 inch rope with a hand braided rawhide nose. The straps for adjustment are made of race track harness leather, the toughest and tightest fibered leather I can buy. This is not latigo leather and will not stretch. The headsetter has stainless steel 5705 buckles on each side which allows you to get exactly the right fit and feel for your horse. The headsetter price does not include a tie down strap but you may purchase a Leather Tiedown Strap #ZG, either 3/4 or 1 inch in width, or a Nylon Tie Down Strap #ZH (shown) with the headsetter. See dropdown to order.
How it works: As the head goes up pressure is applied from the tiedown strap to the nose. This causes the cheek pieces to slide through the nose piece rings until the rings reach the top stop on the cheek pieces. As the cheek pieces are sliding pressure is increased at the poll. This headsetter applies more pressure to the poll than to the nose. The pressure points together cause the horse to lower his head to a natural position to find release. This is a very popular training tool with ropers and barrel racers and can help those horses that have a tendency to raise their heads while roping or barrel racing. Can be a great training aid for other disciplines also. In time, the horse will learn to carry his head lower to avoid the pressure from the headsetter.
Related products
-
No Buckle Hobble with Chain Center #H3C
$102.00Description: This No Buckle Hobble with Chain Center #H3C has an easy “on/off latch” that makes it a snap to take on and off your horse’s fetlocks. It is 1 3/4 inches wide and made of doubled and stitched latigo leather. The smooth stainless steel chain link in the center makes it more flexible than similar hobbles with leather centers such as the #H3L No Buckle Hobble. This should only be used on horses that are completely hobble broke.
Visit “Hobble Along” to read my Tack Talk article on proper and safe use hobbles.
For use only on horses that are hobble broke.
-
1″ Hobble #H1
$85.00Description: This 1″ Hobble #H1 is made of doubled and stitched burgundy latigo leather. The buckle is a stainless steel square top roller buckle and the rings are stainless steel. It is small enough to hang on your saddle rear D and stout enough to last for years.
How it works: This hobble works especially well for sacking out colts and patience training when used in combination with the #SL1 Bronc Sideline (shown on horse in picture). Hobbles are very good for teaching patience, trust in the handler, and responding correctly to pressure.
Many horses have been saved from severe injury when caught in wire because they were hobble trained. A horseman may also teach his or her horse to accept hobbles and sidelines so it won’t need to be tied or ground tied. When a horse is hobbled it won’t hurt its mouth with a jerk from a stepped on or looped rein. Hobbles and sidelines can also have a quieting effect on the horse’s mind. Investing in hobbles and their training can have big pay-backs.
To put a set of hobbles on:
1. Starting with the right front leg, wrap the end of the hobble strap clockwise around the leg and lace it through the first metal ring.
2. Lace the strap through the second ring.
3. Run the strap behind the left front leg.
4. Buckle the strap.
For more information on hobbles read my Tack Talk Article Hobble Along.
The first time you use the hobbles on your colt or horse, or while training the horse to accept hobbles, use a wide open sandy area. Do not put hobbles on in a confined space until they accept them easily and well. If you are not familiar with the use of hobbles seek help from a professional who is experienced with their use.
-
Adjustable Latigo Leather Cavesson #CA5
Price range: $80.00 through $86.25Description: This Adjustable Latigo Leather Cavesson #CA5 is made with a doubled and stitched 5/8 inch burgundy latigo leather noseband. The chin strap and headstall are single ply burgundy latigo leather. This latigo is a soft, pliable leather that feels good on a horse’s face. It’s stout and will last for years of hard use. The buckles and rings are stainless steel. This cavesson is available in small and large sizes. Both sizes are adjustable. The noseband on the small cavesson adjusts between 20 1/2 and 24 inches and the crown adjusts between 30 and 33 inches. The noseband on the large cavesson adjusts between 23 and 27 inches and the crown adjusts between 31 and 38 inches. Generally speaking, the small size will fit the smaller or young horse (approximately 14.2 hands and under) and the large size will fit the mature/bigger horse over 14.2 hands.
Size Measurement: An easy way to be certain to get the correct sized cavesson is to wrap a leadrope around the nose where the cavesson will lay, mark the leadrope with a magic marker, straighten it and then measure the leadrope. When measuring, be sure to wrap the leadrope loosely enough that the horse will have enough room between his nose and the cavesson to be comfortable and to be able to hold the bit. A good rule of thumb is 2 fingers width between the nose and cavesson (which is the diameter of most leadropes) if the horse is trained to a cavesson.
This cavesson is a good starting cavesson and is also good for sensitive horses. It should be adjusted loosely when starting any horse in it.
For more information on cavesson fit and use visit: There’s More to a Cavesson than Meets the Eye: How and Why to Use Cavessons
-
Sliding Gag Bit with Twisted Wire Snaffle #20-42
Price range: $200.00 through $253.00Description: This Dennis Moreland Tack Sliding Gag Bit with Twisted Wire Snaffle #20-42 is built with a center bar on the bit cheeks which limits the movement of the sliding mouthpiece to provide quicker action and instant relief. The hard lay nylon cord allows the bit to slide easily. The cord is attached to a stainless steel buckle which attaches it to adjustable single ply 3/4 inch harness leather cheeks. The twisted wire mouthpiece gives a stronger signal than the common snaffle and is very good to use if your horse has become resistant to giving his nose and/or lowering his head. This snaffle should improve stops in a horse that is trying to run off. This Sliding Gag comes with your choice of a stainless steel twisted wire headstall or, for the more sensitive horse, a 3/4 inch harness leather slide ear headstall or a 3/4 inch browband headstall (see photo).
How it works: The simultaneous pressure on the mouth from the sliding gag bit and on the poll from the twisted, shaped, stainless steel or the leather crown increases control of the nose and improves total balancing power to produce the ultimate in vertical flexion and feel. Because your rein aids are strengthened with the gag, your leg cues given at the same time become reinforced and easier for the horse to respond to. You will be able to better concentrate on fine details of your training rather than large rebalancing or repositioning efforts regardless of your type of riding. This gag bridle is an excellent training tool for both young and older horses that need to improve flexibility and response. Your horse will learn that when it breaks at the poll the release will be instant, smooth, and consistent. Since these gags release so quickly your horse is not trapped in position while it waits for the release to occur. This helps horses stay calm and confident in training and also when they are in competition. The leather crown works well with this twisted wire mouthpiece on horses that want to drop their heads while continuing to pull on the bit.
Although this Sliding Gag is sold without reins, you can choose any Dennis Moreland split reins or roping reins for your sliding gag. To select your reins simply visit the rein category and add them to your order.
If you don’t have experience with sliding gags Dennis Moreland Tack recommends you seek the help of a professional who has experience as you are learning to use them.
-
No Buckle Hobble with Leather Center #H3L
$105.00Description: This No Buckle Hobble with Leather Center #H3L is made of 1 3/4 inch doubled and stitched latigo leather. It has a 3 inch long latigo leather link in the center to separate your horse’s legs. The rings and squares are made of smooth stainless steel. This hobble has an easy “on/off” latch that makes it so quick and simple to take on and off your horse’s fetlocks. This should only be used on horses that are completely hobble broke.
Visit “Hobble Along” to read my Tack Talk article on the safe and proper use of hobbles.
Only for use on horses that are hobble broke.
